The battery on a wireless Honeywell Panel will typically be plugged into the circuit board. On a wireless all-in-one panel, you may have to remove its back cover to access the battery. The location of this battery varies between different systems. Every Honeywell Control Panel has a backup battery. To power off a Honeywell Alarm System, complete the following steps, in this order:ġ. You can confirm that the system has powered on by checking its display screen or keypad. It will usually take a few minutes for this process to complete. The panel should automatically turn back on. When you want to turn your system back on, first plug-in the transformer. Once both are disconnected, the panel will shut down. You should disconnect the backup battery before unplugging the transformer. These include its backup battery and its plug-in transformer. K0022UGV1 12/01 Rev.You can turn off your Honeywell Alarm System by disconnecting both of its power supplies. If zone descriptors are not programmed, the respective zone numbers are announced.Ĭopyright © 2004 Honeywell International Inc. Up to 3 faulted zones are announced with their zone descriptors, if programmed. To Announce Faults: Press the STATUS key a second time within 10 seconds of the first press. Note: Status cannot be announced during the Exit Delay period. “Disarmed Ready to Arm” or “Disarmed Not Ready to Arm”). The respective system status is announced (e.g. To Announce Status: Press the FUNCTION + VOICE + STATUS key once (Voice Chime mode must be “on” see above). If zone descriptors are not programmed, the respective faulted zone numbers are announced. When Voice Chime mode is on, pressing the STATUS key displays and announces current system status and zone descriptors (programmed by your installer) of faulted zones. Voice Status You can use the STATUS key to announce system status and display any system and/or zone faults (if they exist) by first turning on the Voice Chime mode (see above). When off, the sounder will still provide chime when the control’s Chime mode is on. When on, any faulted zone(s) causes a voice status annunciation, chime, and display. Voice Chime On/Off: Press the FUNCTION + VOICE + VOLUME + keys. Voice Chime You can set each Keypad to announce faulted (opened) entry/exit or perimeter zones whenever the control panel’s Chime mode is on by turning on the Voice Chime mode. Each time you enter the command to adjust the volume, the word “CHECK” will be heard to verify the current setting.Volume cannot be adjusted while playing a message. Adjusting message volume also adjusts status volume.To adjust the volume: Press FUNCTION + VOICE + VOLUME keys, then press the desired volume control key ↑ (up) or ↓ (down). The recorded message will remain in memory until a new message is recorded. The recorded message plays and the red MESSAGE LED turns off. After the message is played once the MESSAGE LED will go out. The red MESSAGE LED will flash indicating a message waiting to be played. Note: A message cannot be recorded during the Exit Delay period. The red MESSAGE indicator will light, indicating record in progress. To record a message: Press FUNCTION + VOICE + RECORD keys. Refer to the procedures below when using the Message Center functions.The volume control of the message is adjustable.The message remains in the Keypad’s memory until a new message is recorded.The message can be up to 2.5-minutes long.The ADEMCO 6150V/6160V Keypads feature a voice message center that lets you record and playback one message. Refer to your security system User Guide for all other security system functions and operating procedures. This document provides Operating Instructions for your Keypad’s voice features.

Honeywell alarm keypad m7240